One of the largest stockists of photographic and imaging accessories in Europe
  • PocketWizard Plus III Transceiver Twin S
  • PocketWizard Plus III Transceiver Twin S
  • PocketWizard Plus III Transceiver Twin S
  • PocketWizard Plus III Transceiver Twin S

PocketWizard Plus III Transceiver Twin Set

A set of two PocketWizard Plus III transceivers, to enable advanced, reliable triggering of flashguns (or cameras with adaptor cord) where dedicated flash operation is not required. The Plus III trigger has 32 selectable channels (16 standard, and 16 for quad-zone operation) to ensure no interference with other photographers operating in the same area. Four separate zones can be independently selected to allow single or groups of flashes or cameras to be turned on or off. Using the EC-approved 433MHz wavelegth up to a range of 500m, the Plus III operates as a transmitter or receiver, and automatically detects in which mode it needs to operate (e.g. when attached to a camera hot shoe it sets to transmitter). It can also trigger a flash and a camera simultaneously.
Code: PWP3SET
Quantity:
4-7 Days
£235.00
Add to Basket
  • 32 selectable channels (16 standard, and 16 for quad-zone operation).
  • 4 separate zones can be independently selected to allow flashes or cameras to be turned on or off.
  • Operates as a transmitter or receiver, and automatically detects operation mode.
  • 433MHz operation with a range of up to 500m. In difficult conditions this can be nearly doubled using Long Range Mode, or by using another Plus III as an intermediate repeater. Maximum sync speed may be reduced in these instances.
  • Can trigger a flash and camera simultaneously.
  • Non hotshoe connection is via 3.5mm minijack, and the unit is supplied with 3.5mm-3.5mm, 3.5mm-1/4”, and 3.5mm- locking PC cables.
  • Sync speed up to 1/250th sec focal plane shutter; 1/500th for leaf shutters. Triggering frequency is 12fps, which can be increased to 14.5fps.
  • The unit is powered by 2 x AA batteries. For long-term use a compatible AC adaptor can be plugged into the mini USB socket, which is also used to enable firmware upgrades.